the following choices are on the scsiselect utility menu:

    1 configure/view scsi controller settings

    select this choice to view or change scsi controller settings. to reset the scsi controller to its default values, press f6 and follow the instructions on the screen.

    you can view or change the following controller settings:

    1.scsi controller id

    select this choice to view the scsi controller id, which is typically 7.

    2.scsi controller termination

    this choice is set to enabled and cannot be changed.

    3.boot device configuration

    select this choice to configure bootable-device parameters. you must know the scsi id of the device that you want to configure.

    4.scsi device configuration

    select this choice to configure scsi-device parameters. you must know the scsi id of the device that you want to configure.

    the sync transfer rate is the transfer rate for ultra scsi devices. for ultra3 scsi lvd devices, the maximum rate is 160 mbps; for ultra2 scsi lvd devices, 80 mbps; for fast scsi devices, 20 mbps.

    5.advanced configuration

    select this choice to view or change the settings for advanced configuration options.

    2 scsi disk utilities

    select this choice to view the scsi ids assignments or to format a scsi device. select a device from the list and read the instructions on the screen carefully before making a selection.

    if you press ctrl+a before a selected drive is ready, an unexpected scsi command failure screen might appear. restart the computer and watch the scsiselect messages as each drive spins up. when the selected drive is ready, press ctrl+a.