2 投影机输入端口：control（rs-232c）
safoty
usa
ul1950 3rd edition
canada
csa c22．2 no．950-95
european community
the low voltage directive (73／23／eec)
iec60950 2nd edition，+amd.1，+amd.2，+amd.3，+amd.4
emc
usa
fcc 47cfr partl5b class b (doc)
canada
ices-003 class b
european community
the emc directive(89／336／eec)
en55022，1998 class b
en55024，1998
iec61000-4-2，iec61000-4-3，iec61000-4-4，
iec61000-4-5，
iec61000-4-6，iec61000-4-8，iec61000-4-11，
iec61000-3-2，iec61000-3-3
australia／new zealand
as／nzs 3548：1995，al：1997，a2：1997 class b
cisprpub．22：1993，al：1995，a2：1996，class b
declaration of conformity
according to 47cfr，part 2 and 15
class b pemonal computers and peripherals；and／or
cpu boards and power suppies usad with class b
pemonal computers
we：epson america，inc．
located at：3840 kilrov airport wav
ms：313
lonq beach，ca90806
tel：562-290-5254
declare under sole responsibility that the product identified herein，complies with 47cfr part 2 and 15 of the fcc rules as a class b diqital device．each product marketed，is identical to the representative unit tested and found to be compliant with the standards．records maintained conunue to reflect the equipment being produced can be expected to be within thevariation accepted，due to quantity production and testing on a statistical basis as required by 47cfr 2．909．operation is subject to the following two conditions：(1)this device may not cause harmful interference，and (2) this device must accept any interference received，includinq interference that mav cause undesired operation．
trade name：epson
tvde of product：proiector
model：emp-tw200h
fcc compliance statement
for united states users
this equipment has been tested and found to comply with the limits for a class b digital device，pursuant to part 15 of the fcc rules．these limits are desiqned to provide reasonable protection against harmful interference in a residential installation．this equipment generates，uses，and can radiate radio frequency eriergy and，if not installed and used in accordance with the instructions，mav cause harmful interference to radio or television reception．however,there is no quarantee that interference will not occur in aparticular installation．if this equipment does cause interference to radio and television reception，which can be determined byturning the equipment off and on，the user is encouraged to try to correct the interference bv one or more of the followinq measures．
1 reorient or relocate the receiving antanna．
2 increase the separation between the equipment and receiver．
3 connect the equipment into an outlet on a circuit different from that to which the receiver is connected．
4 consult the dealer or an experiencad radio／tv technician for help．
the connection of a non-shielded equipment interface cable to this equipment will invalidate the fcc certitication or declaration of this device and mav cause interferenoe levels which exceed the limits established by the fcc for this equipment．lt is the responsibility of the user to obtain and use use a shielded equipment interface cable with this device．lf this equipment has more than one interface connector,do not leave cables connected to unused interfaces． changes or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment．