1) if there is no signal present, all source-dependent adjustments are disabled. 2) after 15 minutes of inactivity, the projector leaves the menu system and returns to the presentation. 3) the status menu is read-only.
when finished with a function menu, do one of the following:
press exit to return to the previous screen
press menu to leave the menu system and return to the presentation
on-line help
if at any time you are uncertain what to do next, press help to display summary information about the current menu or highlighted option. press help again to exit. in addition, a line of “hint” text is included at the bottom of some menus.
from presentation level, press help to access general help topics. scroll as necessary within a topic. press help or exit to return to your presentation.
time-outs
if a slidebar, menu, or message is displayed, you have limited time in which to make a keypad entry before the projector returns to presentation level help and the graphic disappears. these time-outs may vary depending on what is displayed.
the global icon
menu options that include this icon apply universally to any incoming signal.
using slidebars and other controls
most of the function menus allow you to change settings by using slidebars, checkboxes, and pull-down lists. to select a slidebar, toggle a checkbox status, or view a pull-down list, do one of the following within the function menu:
enter the menu option number corresponding to the setting you wish to change for example, press 1 3 to select vertical stretch in the size & position menu).
or bypass the menus entirely and use a single key to immediately access an adjustment during your presentation (note: applies only to options having their own key, such as contrast, brightness, gamma, etc.).
for “blind” access, hide the entire menu system (see osd key, above) and/or direct slidebars activated by their own key (such as contrast, brightness, etc.).control by using the proper keypress or numerical sequence of key presses.
“direct” slidebars - for quick access, you access gamma, brightness, and contrast slidebars without traveling the menu system. for example, simply press cont to immediately display the same contrast slidebar accessed with the contrast option in the image settings menu.
1) you can still adjust a direct slidebar as usual if the display is turned off (see osd or menu preferences menu) — the slidebar just won’t be visible. 2) a direct slidebar disappears if it is not used within 5 seconds.
editing text
press exit at any time to cancel changes and return to the previously-defined text.
editing numerical values
enter numbers directly from the keypad in order to specify numbers representing projectors, channels (source setups), or slots. as each digit is entered, it is displayed and the cursor moves on. note that channel numbers are defined with 2 digits—for example, if you enter only a single digit (such as “7”) for a channel number, the channel will automatically be defined as “07”. enter “07” to utilize this channel.
1) once you enter the first digit, this digit replaces all old digits. 2) if you press any non-numbered key, the number entered up to that point is accepted and updated as the new value. 3) press exit to cancel editing of numerical values.