lamp does not ignite

    1. if the lamp won’ t ignite, there may be an interlock failure such as an open lamp door, or failed lamp fan. an error code will display on the status led display located on the built in keypad.

    2. if a temperature is too high (“dmd over critical temp limit”, e.g.), the lamp will not ignite until the temperature is low enough. cool the projector and try again.

    3. for suspected communication failures, power-down the projector and try again.

    4. if the lamp does not ignite after a second and third try, replace the lamp.

    lamp suddenly turns off

    1. try increasing the lamp power.

    2. the dmds may be overheated.

    3. replace the lamp.

    flicker, shadows or dimness

    1. increase lamp power, if possible.

    liteloc . does not seem to work

    1. make sure “intensity” is selected in the lamp menu. other lamp modes disable liteloc. .

    2. if the lamp power has increased to its maximum in order to maintain a liteloc. setting, liteloc. is automatically terminated. if the values shown in the lamp menu indicate that the lamp power has reached this “over-drive” state, either reduce your liteloc. setting or install a new lamp.