roadster s+12k/s+16k mirage s+14k`
display··panel resolution and refresh rate
pixel format (h x v) on 3 dmds 1400 x 1050
refresh rate
roadster s+12k/s+16k 23.97–92 hz
mirage s+14k 92 – 115 hz
brightness ansi 9 point measurement, with fully open optical aperture
roadster s+ 12k 10,000 ansi lumens.
roadster s+ 16k / mirage s+14k 14,000 ansi lumens
contrast ratio
ansi: 450-600:1 (adjustable aperture)
ff: 1500 - 1800:1 (adjustable aperture)
colors and gray scale
default optical color temperature (at all gray levels) 5150k – 6750k
range of adjustment 3200k – 9300k
displayable colors 1.1 billion min.
gray scale resolution 10 bits (non-linear) min.
color primaries (nominal) x y
red 0.660 0.330
green 0.310 0.640
blue 0.145 0.065
lenses··screen widths
lens offsets
maximum offsets are reduced when simultaneously offsetting horizontally and vertically. all measurements are performed from the optical center ±7%.
color primaries (nominal)
inputs··number of inputs
roadster s+12/s+16 5 standard inputs including a dual
sd/hd-sdi
1 input module slot
mirage s+14k 4 standard inputs
2 input module slots
analog: rgb / ypbpr (5 bncs at input 1)
signal types / color spaces 1 rgb
2 ypbpr
3 component video (cvbs), s-video
(y/c)
horizontal frequency range 15 – 120 khz
vertical frequency range . 23.97 – 150 hz
scan format interlaced or progressive
pixel clock rate 220 mhz max.
active pixels per scan line (h) 640 – 2048
active lines per field/ frame (v)200 – 1536
a/d conversion resolution 10-bit
input levels 1.0vp-p ±2 db (0.79vp-p – 1.26vp-p)
r,b,g,y — with sync 0.7vp-p ±2 db (0.56vp-p – 0.88vp-p)
r,g,b — without sync 0.7vp-p ±2 db (0.56vp-p – 0.88vp-p)
pb, pr ± 5v
dc offset 75 ohms
nominal impedance 1.2:1 db @ 200 mhz
specifies frame rate for non-interlaced sources and field rate for interlaced sources. input frequencies higher than the maximum panel refresh rate are displayed at a lower rate.
analog: video (inputs 3 and 4)
signal formats composite-video (cvbs), s-video (y/c)
connectors
1 composite video (input 3) female rca., gold plating tbd
2 s-video (input 4) 4-pin miniature din
video standards ntsc, ntsc 4.43, pal, pal-m,
pal-n, pal-60 & secam
a/d conversion resolution 8-bit
input levels
composite 1.0 vp-p ± 3db (including sync tip)
s-video, luma (y) 1.0 vp-p ± 3db (including sync tip)
s-video, chroma (c) 630 mvp-p nominal (burst)
dc offset ± 2v
nominal impedance 75 ohms
maximum return loss (vswr) 1.2:1 db @ 6 mhz
*to be changed to bnc in newer boards.
analog: sync (interlaced or progressive scan format)
input levels (for composite or separate h & v) 0.5vp-p – 4.0vp-p
impedance (for composite or separate h & v) 75 ohms
sync type (for composite or separate h & v) separate h and v
bi-level or tri-level sync-ongreen
bi-level or tri-level composite
serrations and/or equalization
pulses
macrovision. for stnd. & prog.
video
maximum return loss (vswr)
to be changed to bnc in newer boards.
max. return loss (vswr)
polarity (for composite or separate h & v) positive or negative
dvi-i (input 2)
interface standard ddwg dvi 1.0
signal types / color spaces rgb (digital or analog)
ypbpr (analog)
ycbcr. (digital)
pixel clock rate 25 – 165 mhz
analog sync input impedance 1 kohms
maximum cable length 5 meters (16 ft.)
supports edid and hdcp
for all other dvi specifications, see analog: rgb / ypbpr on previous page. . not supported in v1.0 s/w
dual sd/hd-sdi (input 5, available in 2005 - standard with roadster s+ series)
number of inputs 2, each with active loop-through
connector type bncs, 75 ohms
supported interface standards smpte 259m (13.5 mhz clock modes only)
smpte 292m
signal types / color spaces serial digital ycbcr (4:2:2 only)
pixel clock rates supported 13.5 mhz, 74.25 mhz, 74.25/1.001 mhz
control··wired keypad (converted ir remote keypad)
connector type 3.5 mm phono jack
input levels high = 2.2 v ?5.6 v (or open)
low = -0.6v ?0.9v @ 1ma
voltage output +5vdc ±5%
current output 100 ma nominal, 250 ma max.
ir remote keypad
number of ir sensors on projector. 2 (front and rear)
wavelength of peak sensitivity 950 nm
modulation (carrier) frequency 36 khz (nominal)
encoding method bi-phase
ir reception range 100 ft.
ethernet
number of ports 1
standard 100base-tx
connector type female rj-45
maximum throughpu 115.2 kbps
rs232 serial input
number of ports 2
connectors 1 female 9-pin dsub (in)
1 male 9-pin dsub (out)
maximum bit rate 115.2 kbps
flow control xon/xoff
rs422 serial input
number of connectors 1
connector type female 9-pin dsub
maximum bit rate 115.2 kbps
gpio input
number of i/o lines 7 (each individually assignable as input or output)
connector type 9-pin male d-sub
type of connection dry contact
output sink current (logic low) 100 ma @ 1v
power output +12vdc @ 200 ma max.
power··general
voltage range, nominal 200 – 240 vac ±10%
line frequency, nominal 50 – 60 hz
inrush current 60 a max.
max. current rating
roadster s+12k 15 a (at 200 vac)
roadster s+16k 20 a (at 200 vac)
mirage s+14k 20 a (at 200 vac)
max. power consumption
roadster s+12k 3000 w (at 200 vac)
roadster s+16k 4000 w (at 200 vac)
mirage s+14k 4000 w (at 200 vac)
current rating of ac input connector
roadster s+12k 15 a
roadster s+16k 20 a
mirage s+14k 20 a
type of connector
roadster s+12k iec320-c14
roadster s+16k iec320- c19
mirage s+14k iec320- c19
line cords
roadster s+12k heavy duty, high current, 15 amp
roadster s+16k heavy duty, high current, 20 amp
mirage s+14k heavy duty, high current, 20 amp
plugs
roadster s+12k nema 6-15p, 15 a, 250 vac
roadster s+16k nema 6-20p, 20 a, 250 vac
mirage s+14k nema 6-20p, 20 a, 250 vac
lamp (dc)
type bubble xenon lamp
power
roadster s+12k 2.0 kw
roadster s+16k 2.4 kw
mirage s+14k 2.4 kw
adjustment ranges
roadster s+12k 1200 – 1900 w
roadster s+16k 1500 – 2400 w
mirage s+14k 1500 – 2400 w
lamp life (warranty hrs.)
roadster s+12k 1000 hours
roadster s+16k 750 hours
mirage s+14k 750 hours
warm-up time to full brightness 10 minutes max.
operating position any vertical angle, ±15o horizontal
audible noise··58 dba max. sound power (average at 1 meter, all four sides)
safety
1 ul 60950and can/csa c22.2. no. 60950 (2000, 3rd edition bi-national)
2 iec 60950 (1999, 3rd edition)
3 china compulsory certification (ccc) tbd
emc emissions
fcc cfr47, part 15, subpart b, class a — unintentional radiation cispr 22: 1997 / en55022: 1998 — radio disturbance characteristics for ite
emc immunity
cispr 24 / en55024:1998 (all parts of immunity characteristics for ite)
operating environment
temperature 5℃ to 35℃ (41°f to 95°f)
humidity (non-condensing) 20% to 80%
altitude 0 – 3000 meters
tilt, any angle 15° max.
non-operating environment
temperature -40c to 70°c (-40f to 149°f)
humidity (non-condensing) 0% to 95%
size & weight'
size (w x l x h of product only, no lens) 24” (61 cm) x 32” (81.3 cm) x 15” (38.1cm)
(including feet at minimum height position)
weight of product (without lens, stackers)
roadster s+12k 140 lb (63.6 kg)
roadster s+16k 145 lb. (65.9 kg)
mirage s+14k 145 lb. (65.9 kg)
shipping weight in standard packaging
roadster s+12k 165 lb (75 kg)
roadster s+16k 170 lb. (77.3 kg)
mirage s+14k 170 lb. (77.3 kg)
standard components
roadster s+12k/16k
ir remote keypad (batteries included)
line cord
user’s manual
dual sd/hd-sdi interface module
stacking mounts
integral rigging hardware
mirage s+14k
ir remote keypad (batteries included)
line cord
user’s manual
3d stereo inverting cable (available 2005)
options
lenses (for standard motorized “compact” thunder lens mount)
1 0.73 : 1 fixed lens rp – part # 38-809088-01
2 1.2 : 1 fixed lens fp available march, 2005)
3 1.45-1.8 :1 zoom – part # 38-8090089-01
4 1.8-2.5 :1 zoom – part # 38-809090-01
5 2.5-4.5 :1 zoom – part # 38-809091-01
6 4.5-7.3 :1 zoom – part # 38-809092-01
manual lens mount for “legacy” thunder lenses
accessories
remote ir sensor
service manual
kore librarian
stacking hardware for mirage s+14k
optional interface modules
rgb500 input module
rgb400 alt input module
composite video input module
pc250 analog input module
dvi input module
digital hdtv input module
serial digital input module (sdi)