1. state: displays the status of each port (“on” means enable and “off” means disable). “unlink” will be treated as “off ”.
2. link status: “down” and “up” means “no link” and “link” respectively.
3. negotiation: displays the auto negotiation modes: auto, force and nway-force.
4. speed status: displays the speed of each port:
port 1- 24 are 10/100mbps
port 25-26 are 10/100/1000mbps(gigabit ethernet switch) 10/100mbps(fast ethernet switch)
5. duplex status: displays the port is full-duplex mode or half-duplex mode.
6. flow control:
full: displays the flow control status is enable or disable in full duplex mode.
half: displays the backpressure is enable or disable in half duplex mode.
7. rate control: displays the rate control settings.
ingr: displays the port’s effective ingress rate of user settings.
egr: displays the port’s effective egress rate of user settings.
8. port security: shows the port security is enabled or disabled.
9. config: displays the state of user’s settings.
10. atual: displays the negotiation results.
you can see a single port counter by clicking on each port as following.
