1. inrate(100k/unit): you can set input rate control, per unit is100k. the valid range is 0～1000.
0: disable rate control.
1～1000: valid rate value.
2. outrate(100k/unit): you can set output rate control, per unit is 100k. the valid range is 0～1000.
0: disable rate control.
1～1000: valid rate value.
3.enable: you can disable or enable this port control. “yes” means the port is enabled, “no” means the port is disabled.
4.auto: you can set auto-negotiation mode as auto, nway_force or force of each port.
5.spd/dpx: you can set 100/10mbps speed on port 1～port24; 1000/100/10mbps speed on port25～port26 (gigabit switch), 100/10mbps speed on port25～port26 (fast ethernet switch) and set full-duplex or half-duplex mode.
6. flow control:
full: displays the flow control status is enable/disable in full duplex mode.
half: displays the backpressure is enable/disable in half duplex mode.
1. pressing [save] only can save one page configuration.
2. if the static trunk group exists, you can see it (ex: trk1, trk2…) after port 26, and you can configure all of the items as above.