1. start the tftp server.
2. press [edit] on this page.
3. tftp server: type the ip of tftp server.
4. remote file name: type the image file name.
5. press ctrl+a go to action line.
6. press [save] key, it will start to upload the image file.
7. when save successfully, the image file upload finished too.
8. restart switch.
troubleshooting
1. power led is not lit
check if the power cord is properly connected to the power outlet and the switch. make sure the power switch at the rear panel is turned on.
2. link led is not lit when connected to the network device
(1) make sure the power switch of the network device is turned on
(2) check if the network cable is properly connected to the switch and the network device
(3) make sure the utp cables comply with eia/tia 568 and category 5 specification
3. collision led flashes constantly
(1) remove all the network cables; connect the cables back one by one to isolate the source of the collision.
(2) check the network cable, inferior cable quality will result in excessive collisions and packet errors.
contact your dealer if problems persist.