these warnings are translated into several languages in the regulatory compliance and safety information for the catalyst 2960 switch document that shipped with the switch.

    1 attach only the cisco rps (model pwr675-ac-rps-n1) to the rps receptacle. statement 100c

    2 attach only the cisco rps (model pwr300-ac-rps-n1) to the rps receptacle. statement 100b

    3 only trained and qualified personnel should be allowed to install, replace, or service this equipment. statement 1030

    4 read the installation instructions before connecting the system to the power source. statement 1004

    5 before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches). metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals. statement 43

    6 do not stack the chassis on any other equipment. if the chassis falls, it can cause severe bodily injury and equipment damage. statement 48

    7 the plug-socket combination must be accessible at all times, because it serves as the main disconnecting device. statement 1019

    8 this equipment must be grounded. never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. statement 1024

    9 when installing or replacing the unit, the ground connection must always be made first and disconnected last. statement 1046

    10 to prevent the switch from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature of 113℉(45℃). to prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around the ventilation openings. statement 17b

    11 do not work on the system or connect or disconnect cables during periods of lightning activity. statement 1001

    12 ultimate disposal of this product should be handled according to all national laws and regulations. statement 1040.

    13 to prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. the following guidelines are provided to ensure your safety:

    a、this unit should be mounted at the bottom of the rack if it is the only unit in the rack.

    b、when mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

    c、if the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. statement 1006

    14 if a redundant power system (rps) is not connected to the switch, install an rps connector cover on the back of the switch. statement 265

    15 to comply with safety regulations, mount switches on a wall with the front panel facing up. statement 266

    16 ethernet cables must be shielded when used in a central office environment. statement 171

    17 for connections outside the building where the equipment is installed, the following ports must be connected through an approved network termination unit with integral circuit protection: 10/100/1000 ethernet. statement 1044

    18 installation of the equipment must comply with local and national electrical codes. statement 1074

    19 class 1 laser product. statement 1008