these warnings are translated into several languages in the regulatory compliance and safety information for the catalyst 3560 switch document that shipped with the switch.

    voltages that present a shock hazard may exist on power over ethernet (poe) circuits if interconnections are made using uninsulated exposed metal contacts, conductors, or terminals. avoid using such interconnection methods, unless the exposed metal parts are located within a restricted access location and users and service people who are authorized within the restricted access location are made aware of the hazard. a restricted access area can be accessed only through the use of a special tool, lock and key or other means of security. statement 1072

    this unit is intended for installation in restricted access areas. a restricted access area can be accessed only through the use of a special tool, lock and key, or other means of security. statement 1017

    attach only the cisco rps (model pwr675-ac-rps-n1) to the rps receptacle. statement 100c

    class 1 laser product. statement 1008

    only trained and qualified personnel should be allowed to install, replace, or service this equipment. statement 1030

    read the installation instructions before connecting the system to the power source. statement 1004

    before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches). metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals. statement 43

    do not stack the chassis on any other equipment. if the chassis falls, it can cause severe bodily injury and equipment damage. statement 48

    the plug-socket combination must be accessible at all times, because it serves as the main disconnecting device. statement 1019

    this equipment is intended to be grounded. ensure that the host is connected to earth ground during normal use. statement 39

    when installing or replacing the unit, the ground connection must always be made first and disconnected last. statement 1046

    to prevent the switch from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature of 113℉ (45℃). to prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around the ventilation openings. statement 17b

    do not work on the system or connect or disconnect cables during periods of lightning activity. statement 1001

    ultimate disposal of this product should be handled according to all national laws and regulations.statement 1040

    if a redundant power system (rps) is not connected to the switch, install an rps connector cover on the back of the switch. statement 265

    to prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. the following guidelines are provided to ensure your safety:

    1.this unit should be mounted at the bottom of the rack if it is the only unit in the rack.

    2.when mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

    3.if the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. statement 1006

    to comply with safety regulations, mount switches on a wall with the front panel facing up.statement 266

    this unit is intended for installation in restricted access areas. a restricted access area is where access can only be gained by service personnel through the use of a special tool, lock and key, or other means of security, and is controlled by the authority responsible for the location. statement 37

    ethernet cables must be shielded when used in a central office environment. statement 171

    avoid direct exposure to the laser beam. statement 1012

    invisible laser radiation may be emitted from disconnected fibers or connectors. do not stare into beams or view directly with optical instruments. statement 1051