the catalyst 4510r switch supports the supervisor engine v and v-10ge. the supervisor engine has a nonblocking, full-duplex, switching fabric that provides connections between the supervisor engine and the switching modules. the gigabit ethernet ports can be configured with any combination of copper 1000base-t, shortwave sx, lx/lh, and zx interfaces, or cwdm and dwdm gbics. for a description of gbics, refer to the catalyst 4500 series module
installation guide or the catalyst 4500 series supervisor engines and switching modules installation note. some supervisor engines use sfp modules for gigabit ethernet connections, or x2 modules for 10 gigabit ethernet connections. refer to the installation note for your supervisor engine for more details on these modules.
slot 1 is reserved for the supervisor engine only, which provides switching, local and remote management, and switch-status monitoring. slot 2 is reserved for a redundant supervisor engine only. slots 3 through 9 are available for switching modules. when using a supervisor engine v, slot 10 is a flex-slot for use with the 2-port gigabit ethernet switching module (ws-x4302-gb) or the access gateway module (ws-x4604-gwy) only. when using a supervisor engine v-10ge, any supported module may be used in slot 10.
table 1-4 describes the features of the catalyst 4510r switch.
1. you will need to configure the 1400 w dc input current as appropriate for the model of switch. refer to appendix a,“specifications.”
2. the 1000 w ac and 1300 w ac power supplies for the catalyst 4500 series will fit and function in a catalyst 4510r;however, power management may be required in high-density configurations.