the extraction process varies among different mini-gbics (see the illustrations and examples in this section). the mini-gbic removal process is essentially to disengage the unit from its port via the extraction mechanism, then pull the unit straight out of the receptacle.
you should disconnect the network cable from the mini-gbic before removing it from the module.
depending on when you purchased your procurve mini-gbic, it may have one of three different release mechanisms: a plastic tab on the bottom, a wire bail, or a plastic collar around the mini-gbic (see the following pages for details).
to remove the a mini-gbic with a plastic tab or plastic collar:
1. remove the fiber cable from the mini-gbic.
2. push in the plastic tab or collar toward the switch until you see the mini-gbic release from the switch (you can see it move outward slightly)
3. pull the mini-gbic from the slot.
4. if the device is not defective (disposable), insert a dust plug to protect it.
to remove a mini-gbic with a wire bail:
1. remove the fiber cable from the mini-gbic.
2. lower the bail until it is approximately horizontal.
3. using the bail, pull the mini-gbic from the slot.
4. if the mini-gbic is not defective (disposable), protect it by inserting a dust plug.
