before reinstalling the cover on the router, make sure that all cables are securely tucked in and are not in danger of being pinched or cut.

    step 1 place the chassis on a flat surface.

    step 2 hold the cover at a 45-degree angle, and insert the tabs into the slots along the front (bezel) edge of the chassis. (see figure 5-26.)

    step 3 center the cover over the chassis and lower it onto the chassis.

   

    step 4 reinstall the cover screws.

    step 5 reinstall the chassis on a rack or desktop.

    step 6 reconnect network interface cables.

    step 7 power on the router.

    after wiring the dc power supply, remove the tape from the circuit breaker switch handle and reinstate power by moving the handle of the circuit breaker to the on position. to see translations of the various warnings that appear in this publication, refer to the regulatory compliance and safety information document that accompanied this device.