the proper operation of the function requires a computer with vesa dpms power management capabilities. when used with a computer equipped with vesa dpms, the monitor is energy star-compliant.
as an energy star?/sup] partner, dell inc. has determined that this product meets the energy star?/sup] guidelines for energy efficiency.
federal communications commission (fcc) notice (u.s. only)
this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the fcc rules. these limits are designed to provide reasonable protection against harmful interference in a residential installation. this equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. however, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
1、reorient or relocate receiving antenna.
2、increase the separation between the equipment and receiver.
3、connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4、consult the dealer or an experienced radio/tv technician for help.
this device complies with part 15 of the fcc rules. operation is subject to the following two conditions:
1、this device may not cause harmful interference.
2、this device must accept any interference received including interference that may cause undesired operation.
instructions to users: this equipment complies with the requirements of fcc (federal communication commission) equipment provided that following conditions are met.
1、video inputs: the input signal amplitude must not exceed the specified level.
changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
ce declaration of conformity
ce declaration of conformity
for a class b digital device
directives to which conformity is declared
emc directives 89/336/eec and amending directive 92/31/eec
and
low voltage directive 73/23/eec
standards to which conformity is declared
en60950:2000, en55022: 1998+a1, en55024: 1998+a1, en61000-3-2: 2000, and en61000-3-3:1995+a1
i, the undersigned, hereby declare that the equipment specified above conforms to the above directive(s) and standards.
canadian regulatory information (canada only)
this digital apparatus does not exceed the class b limits for radio noise emissions from digital apparatus set out in the radio interference regulations of the canadian department of communications.
note that canadian department of communications (doc) regulations provide, that changes or modifications not expressly approved by dell computer corporation could void your authority to operate this equipment.
this class b digital apparatus meets all requirements of the canadian interference-causing equipment regulations.
en 55022 compliance (czech republic only)
vcci class 2 notice (japan only)
this equipment complies with the limits for a class 2 digital device (devices used in or adjacent to a residential environment) and conforms to the standards for information technology equipment that are set by the voluntary control council for interference for preventing radio frequency interference in residential areas.
mic notice (south korea only)
please note that this device has been aproved for nonbusiness purposes and may be used in any environment, including residential areas.
polish center for testing and certification notice
the equipment should draw power from a socket with an attached protection circuit (a three-prong socket). all equipment that works together (computer, monitor, printer, and so on) should have the same power supply source.
the phasing conductor of the room's electrical installation should have a reserve short-circuit protection device in the form of a fuse with a nominal value no larger than 16 amperes (a).
to completely switch off the equipment, the power supply cable must be removed from the power supply socket, which should be located near the equipment and easily accessible.
a protection mark "b" confirms that the equipment is in compliance with the protection usage requirements of standards pn-93/t-42107 and pn-89/e-06251.
nom information (mexico only)
the following information is provided on the device(s) described in this document in compliance with the requirements of the official mexican standards (nom)
bsmi notice (taiwan only)
ergonomics notice (germany only)
under the requirements of german ergonomics standard ek 1/59-98, ek 1/60-98, graphics or characters:
1、blue graphics or characters in dark background are not recommended. (this combination may increase eye fatigue due to poor visibility caused by low contrast.)
2、graphics controller and monitor are recommended to be used in the following conditions:
①vertical frequency : 70 hz or higher.
②display mode : dark characters in bright background.
ergonomie hinweis (nur deutschland)
um den anforderungen der deutschen ergonomie-norm ek 1/59-98, ek 1/60-98 zu antsprechen.
1、wird empfahlen, die grunfarbe blau nicht auf dunklem hintergrund zu verwenden (schiechte erkennbarkeit. augenbelastung bei zu geringem zeicheenkontrast).
2、wird folgende einstellung des grafik-controllers und monitors empfohlen.
①vertikalfrequenz : 70 hz oder hoher.
②ohne zellensprung.
aus ergonomischen grunden wird empfohlen, die grundfarben blau und rot nicht auf dunklem untergrund zu verwenden (schlechte lesbarkeit und erhohte augenbelastung bei zu geringem zeichenkontrast waren die folge).
der arbeitsplatzbezogene schaldruckpegel nach din 45 635 bertragt 70db (a) oder weniger.
north europe information
placering/ventilation
varning:
forsakra dig om att huvudbrytare och uttag ar latatkomliga, nar du staller din utrustning paplats.
placering/ventilation
advarsel:
paikka/ilmankierto
varoitus:
sijoita laite siten, etta verkkojohto voidaan tarvittaessa helposti irrottaa pistorasiasta.
plassering/ventilasjon
advarsel:
information for users in the u.s.
for units set at 115v:
use a ul listed cord set consisting of a minimum 18 awg, type svt or sjt three conductor cord a maximum of 15-feet in length and a parallel blade, grounding type attachment plug rated 15 a, 125v.
for units set at 230v:
use a ul listed cord set consisting of a minimum 18 awg, type svt or sjt three conductor cord a maximum of 15-feet in length and a tandem blade, grounding type attachment plug rated 15 a, 250v.
information for users outside the u.s.
for units set at 230v:
use a cord set consisting of a minimum 18 awg cord and grounding type attachment plug rated 15 a, 250v. the cord set should have the appropriate safety approvals for the country in which the equipment will be installed and/or marked har.
aus ergonomischen grunden wird empfohlen, die grundfarben blau und rot nicht auf dunklem untergrund zu verwenden (schlechte lesbarkeit und erhohte augenbelastung bei zu geringem zeichenkontrast waren die folge).
der arbeitsplatzbezogene schaldruckpegel nach din 45 635 bertragt 70db (a) oder weniger.
regulatory listing
safety certifications:
1、ul 1950
2、csa 950
3、nom
4、ce mark—en60950:2000
5、nemko
6、semko
7、demko
8、fimko
9、ezu
10、iec 950
11、tuv gs
12、pcbc
13、gost
14、ccib
15、ktl
16、psb
emc certifications:
1、fcc part 15 class b
2、dhhs fda cfr 21 subchapter j
3、ce mark—en55022:1998 class b, en61000-3-2:1995, en61000-3-3:1995, en55024:1998
4、ices-003
5、ezu
6、nemko
7、semko
8、demko
9、fimko
10、pcbc
11、gost
12、c-tick
13、vcci class b ite
14、mic
15、bsmi
ergonomics:
tco '99 information (for tco model only)
congratulations!
you have just purchased a tco' 99 approved and labeled product! your choice has provided you with a product developed for professional use. your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products.
why do we have environmentally labeled computers?
in many countries, environmental labeling has become an established method for encouraging the adaptation of goods and services to the environment. the main problem, as far as computers and other electronics equipment are concerned, is that environmentally harmful substances are used both in the products and during their manufacture. since it is not so far possible to satisfactorily recycle the majority of electronics equipment, most of these potentially damaging substances sooner or later enter nature.
there are also other characteristics of a computer, such as energy consumption levels, that are important from the viewpoints of both the work (internal) and natural (external) environments. since all methods of electricity generation have a negative effect on the environment (e.g. acidic and climate-influencing emissions, radioactive waste), it is vital to save energy. electronics equipment in offices is often left running continuously and thereby consumes a lot of energy.
what does labeling involve?
this product meets the requirements for the tco' 99 scheme which provides for international and environmental labeling of personal computers. the labeling scheme was developed as a joint effort by the tco (the swedish confederation of professional employees), svenska naturskyddsforeningen (the swedish society for nature conservation) and statens energimyndighet (the swedish national energy administration).
approval requirements cover a wide range of issues: environment, ergonomics, usability, emission of electric and magnetic fields, energy consumption and electrical and fire safety.
the environmental demands impose restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, cfcs (freons) and chlorinated solvents, among other things. the product must be prepared for recycling and the manufacturer is obliged to have an environmental policy which must be adhered to in each country where the company implements its operational policy.
the energy requirements include a demand that the computer and/or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. the length of time to reactivate the computer shall be reasonable for the user.
labeled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability.
below you will find a brief summary of the environmental requirements met by this product. the complete environmental criteria document may be ordered from:
tco development
se-114 94 stockholm, sweden
fax: +46 8 782 92 07
email (internet): development@tco.se
current information regarding tco' 99 approved and labeled products may also be obtained via the internet, using the address: http://www.tco-info.com/
environmental requirements
flame retardants
flame retardants are present in printed circuit boards, cables, wires, casings and housings. their purpose is to prevent, or at least to delay the spread of fire. up to 30% of the plastic in a computer casing can consist of flame retardant substances. most flame retardants contain bromine or chloride, and those flame retardants are chemically related to another group of environmental toxins, pcbs. both the flame retardants containing bromine or chloride and the pcbs are suspected of giving rise to severe health effects, including reproductive damage in fish-eating birds and mammals, due to the bio-accumulative* processes. flame retardants have been found in human blood and researchers fear that disturbances in fetus development may occur.
the relevant tco' 99 demand requires that plastic components weighing more than 25 grams must not contain flame retardants with organically bound bromine or chlorine. flame retardants are allowed in the printed circuit boards since no substitutes are available.
cadmium**
cadmium is present in rechargeable batteries and in the color-generating layers of certain computer displays. cadmium damages the nervous system and is toxic in high doses. the relevant tco' 99 requirement states that batteries, the color-generating layers of display screens and the electrical or electronics components must not contain any cadmium.
mercury**
mercury is sometimes found in batteries, relays and switches. it damages the nervous system and is toxic in high doses. the relevant tco' 99 requirement states that batteries may not contain any mercury. it also demands that mercury is not present in any of the electrical or electronics components associated with the labeled unit.
cfcs (freons)
the relevant tco' 99 requirement states that neither cfcs nor hcfcs may be used during the manufacture and assembly of the product. cfcs (freons) are sometimes used for washing printed circuit boards. cfcs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with increased risks e.g. skin cancer (malignant melanoma) as a consequence.
lead**
lead can be found in picture tubes, display screens, solders and capacitors. lead damages the nervous system and in higher doses, causes lead poisoning. the relevant tco' 99 requirement permits the inclusion of lead since no replacement has yet been developed.
* bio-accumulative is defined as substances which accumulate within living organisms.
** lead, cadmium and mercury are heavy metals which are bio-accumulative.
tco' 03 information
some of the features of the tco'03 display requirements.
ergonomics
good visual ergonomics and image quality in order to improve the working environment
for the user and to reduce sight and strain problems. important parameters are luminance,
contrast, resolution, reflectance, colour rendition and image stability.
energy
1、energy-saving mode after a certain time-beneficial both for the user and the environment
2、electrical safety
emissions
1、electromagnetic fields
2、noise emissions
ecology
1、the product must be prepared for recycling and the manufacturer must have a certified
environmental management system such as emas or iso 14 000
2、restrictions on
①chlorinated and brominated flame retardants and polymers
②heavy metals such as cadmium, mercury and lead.
the requirements included in this label have been developed by tco development in co-operation with scientists, experts, users as well as manufacturers all over the world. since the end of the 1980s tco has been involved in influencing the development of it equipment in a more user-friendly direction. our labelling system started with displays in 1992 and is now requested by users and it-manufacturers all over the world.
for more information, please visit
www.tcodevelopment.com
recycling information for customers
dell inc. offers asset recovery programs in many countries. for more information, please contact your dell sales account team; or for general information about dell's recovery programs visit www.dell.com/recycling and www.dell.com/environment.