input characteristics:
1 voltage: 90～240 vac full range.
2 frequency: 47～63 hz.
3 input current: 6/7/8.0 a (rms) for 115vac, 3/3.5/4.0 a (rms) for 230vac.
4 inrush current: 65a max. for 115 vac, 125a max. for 230 vac.
output characteristics:
remark (去掉s): output current of 5v & 3.3v combined should not exceed 45a.
specification:
1、temperature range: operating 0℃---40℃.
2、hold up time: 16 ms minimum at full load & normal input voltage.
3、dielectric withstand: input / output 1500 vac for 1 second.
input to frame ground 1500 vac for 1 second.
4、efficiency: 68% typical.
5、power good signal: on delay 100 ms to 500 ms, off delay 1 ms.
6、over load protection: 130 +/- 20%.
over voltage protection:
+5v→5.7v～6.5v, 3.3v→3.9～4.3v, 12v→13.6～15v.
1、short circuit protection: +5v, -5v, +12v, -12v, +3.3v.
2、emi noise filter: fcc class b, cispr22 class b.
3、safety: ul 1950, csa 22.2 no/ 950, tüv iec 950.
4、remote on / off control.
the unit shall accept a logic open collector level which will disable / enable all output voltages (exclude +5v standby),
as logic level is low, output voltages were enable,
as logic level is high, output voltages were disable.
5、3.3v / 5v remote sensing.
6、cooling: one 80mm dc ball bearing fan.
7、dimension: 140 (d)×150 (w)×86 (h) mm (ps/2).
8、active power factor correction meet iec-1000-3-2 class d.
9、advanced thermal & acoustics control features.
请对照实际购买的产品型号。
input characteristics:
1、voltage: 90～264 vac full range.
2、frequency: 47～63 hz.
3、input current: 8.0 a for 115 vac, 4.0 a for 230 vac.
4、inrush current: 65 a max. for 115 vac, 125 a max. for 230 vac.
output characteristics:
remark: total output should not exceed 460w/500w for hp2-6460p/6500p.
*** when performing cross regulation test, it is requested to set the higher output channel at 90% maximum and the lower output channels at 20% mininum of rated spec.
1、temperature range: operating 0℃--- 40℃, storage–20℃ --- 70℃.
2、humidity: 10 ~ 90 % rh.
3、hold up time: 16 ms minimum at full load & 90 vac input voltage.
4、dielectric withstand: input / output 1500 vac for 1 minute,
input to frame ground 1500 vac for 1 minute.
5、efficiency: 71% typical, at full load, 115vac.
6、power good signal: on delay 100 ms to 500 ms, off delay 1 ms
7、over load protection: 110 ~ 150% max.
8、over current protection:
+5v→44 a～60 a, +3.3v→33 a～45 a, 12v→35.2 a～48.0 a.
over voltage protection:
+5v→5.7v～6.5v, 3.3v→3.9～4.3v, 12v→13.6～15v.
9、emi: meet fcc class b, cispr22 class b.
10、safety: ul 1950, csa 22.2 no/ 950, tüv iec 950.
11、remote on / off control.
12、short circuit protection: shutdown and latch.
13、built-in active power factor corrector.
14、dimension: 86(h) x 150(w) x 140 (d) mm (ps/2).
15、cooling: one 80 mm dc ball bearing fan.
请对照实际购买的产品型号。
input characteristics:
1、voltage: 90 ~ 264 vac full range.
2、frequency: 47 ~ 63 hz.
3、input current: 10.0 a for 115 vac, 5.0 a for 230 vac.
4、inrush current: 65 a max. for 115 vac, 125 a max. for 230 vac.
output characteristics:
remark: 12v total output max. 40a.
remark: total output should not exceed 550w/600w for psm-655p/6600p.
*** when performing cross regulation test, it is requested to set the higher output channel at 90% maximum and the lower output channels at 20% mininum of rated spec.
1、temperature range: operating 0℃---40℃, storage–20℃--- 70℃.
2、humidity: 10 ~ 90 % rh.
3、hold up time: 16 ms minimum at full load & 90 vac input voltage.
4、dielectric withstand: input / output 1500 vac for 1 minute,
input to frame ground 1500 vac for 1 minute.
5、efficiency: 70% typical, at full load, 115vac.
6、power good signal: on delay 100 ms to 500 ms, off delay 1 ms.
7、over load protection: 110 ~ 150% max.
8、over current protection:
+5v→33 a ~ 45 a, + 3.3v→33 a ~ 45 a, 12v1→19.8 a ~ 25.2 a 12v2→19.8 a ~ 25.2 a.
over voltage protection:
+5v→5.7v ~ 6.5v, 3.3v→3.9 ~ 4.3v, 12v1→13.6 ~ 15v 12v2→13.6 ~ 15v.
9、emi: meet fcc class b, cispr22 class b.
10、safety: ul 1950, csa 22.2 no/ 950, tüv iec 950.
11、remote on / off control.
12、short circuit protection: shutdown and latch.
13、built-in active power factor corrector.
14、dimension: 86(h)×150(w)×160 (d) mm (stretch ps/2, eps12v).
15、cooling: one 80 mm dc ball bearing fan.
请对照实际购买的产品型号。
input characteristics:
1、voltage: 90 ~ 264 vac full range.
2、frequency: 47 ~ 63 hz.
3、input current: 10.0 / 11.0 / 12 a for 115 vac, 5.0 / 5.5 / 6.0 a for 230 vac.
4、inrush current: 65 a max. for 115 vac, 125 a max. for 230 vac.
output characteristics:
remark: total output power should not exceed 700w for psl-6701p.
*** when performing cross regulation test, it is requested to set the higher output channel at 90% maximum and the lower output channels at 20% mininum of rated spec.
1、temperature range: operating 0℃---40℃, storage –20℃---70℃.
2、humidity: 10 ~ 90 % rh.
3、hold up time: 16 ms minimum at full load & 90 vac input voltage.
4、dielectric withstand: input / output 1500 vac for 1 minute,
input to frame ground 1500 vac for 1 minute.
5、efficiency: 70% typical, at full load.
6、power good signal: on delay 100 ms to 500 ms, off delay 1 ms.
7、over load protection: 110 ~ 160% max.
8、over voltage protection:
+5v→5.7v ~ 6.5v, 3.3v→3.9 ~ 4.3v, 12v→13.6 ~ 15v.
9、emi: meet fcc class b, cispr22 class b.
10、safety: meet ul 1950, csa 22.2 no/ 950, tüv iec 950.
11、remote on / off control.
12、short circuit protection: shutdown and latch.
13、remote sensing on 3.3 v design.
14、meet iec-1000-3-2 class d (active pfc).
15、dimension: 86(h)×150(w)×220 (d) mm (stretch ps/2).
16、cooling: one 80 mm dc ball bearing fan.
17、i2c features (optional).