2. ensure that the bezel is correctly oriented, align the two plastic bezel hinges with their bezel slots on the right-hand side of the chassis, and then close the bezel. after closing the bezel, confirm that the tabs on the left side are fully seated flat against the chassis.
3. insert the flanges located on the bottom edge of the cover into their slots on the bottom left edge of the workstation. see figure 1-9. next rotate the cover into place as shown by the arrow. you will hear the cover snap into place when the cover is securely closed.
4. lock the cover using the key provided, if required. reconnect all the power and telecommunication cables.