the des-1004 comes complete with a wall mount kit. this kit includes two screws and two plastic anchors. for a proper placement on the wall, follow these steps:

    ◆select a site that is free of obstructions from other equipment or devices. consider the following points for site selection:

    ◆the switch should be placed high enough where led indicators can be observed and cable and power connections can be made.

    ◆moreover, decide whether you would like the switch to point with the front panel facing either up or down.

    ◆drill two holes into the wall with the same distance as the screw support holes located on the bottom of the switch. do not drill these holes too deep.

    ◆insert the plastic anchors into the holes in the wall and secure them with gentle taps of a hammer.

    ◆screw in the screws provided with the wall mount kit into the plastic anchors. do not insert the screws with excessive torque. note that the screw's head along with a small portion of the screw's body should be sticking out.

    ◆gently, place the switch onto the wall with the front panel facing up or down by sliding the screws into the provided slots.

    ◆make all power and network connections at this time, see connecting the switch.