remove the shipping retainer:
1. place the scanner on its side as shown to reveal the shipping retainer as shown in figure 2-1.
2. unscrew the retainer screw.
3. pull out the shipping retainer and put it in the "use position"(see figure 2-2) and secure it with the screw.
4. lay down the scanner on the desk for normal operation.
figure 2-1 remove the shipping retainer.
figure 2-2 fasten the shipping retainer.
refit the shipping retainer:
whenever you need to transport the scanner, please follow the instructions below:
1. turn off the scanner.
2. raise the document cover. you can see clearly the flatbed glass as well as the reading engine.
3. turn on the scanner. at this moment, the reading engine will move a few inches forward and stay there for a few seconds. turn off the scanner during this pause.
4. raise the scanner high enough to unscrew the shipping retainer from the "use position" and fix it in the "shipping position."
scsi id:
when you have several devices on a scsi chain, you may need to adjust the scsi id selector setting located on the back of the scanner(see figure 2-3). this setting assigns a specific "device id" to the scanner. if the id number is duplicate with an existing scsi device, please select a new id.
the factory setting for the scanner is id# 6. usually, id# 0 is assigned to an internal hard disk drive, and id# 7, to scsi adapter or host. id# 8 and #9 are not in use actual.
setting terminator
the scanner is equipped with a built-in terminator switch on the rear of the scanner. (see figure 2-3) turn the terminator switch on if the scanner is to be connected to the computer as the only or the last scsi device. turn the terminator switch off if the scanner is to be located between the computer and other scsi device.
figure 2-3 scsi id setting/terminator switch