2 press point down button to move a red-frame pointer to the item that you want to set and then press set button. setting dialog box appears.
languagelanguage used in on-screen menu is selectable from among english, german, french, italian, spanish, portuguese, dutch, swedish, chinese, korean and japanese.
keystonewhen the image is distorted vertically, select keystone. onscreen menu disappears and keystone dialog box is displayed. correct keystone distortion by pressing point up/down button(s). refer to keystone adjustment on page 20.
blue backwhen this function is "on," this projector will produce a blue image instead of the video noise on the screen when any input source is unplugged or turned off.
displaythis function decides whether to display on-screen displays.
on……shows all the on-screen displays.
off……sets on-screen displays disappeared except;
· on-screen menu
· "power off?" message
logowhen this function is "on," projector displays our logo when starting up.
ceilingwhen this function is "on," picture is top / bottom and left / right reversed. this function is used to project the image from a ceiling mounted projector.
rearwhen this function is "on," picture is left / right reversed. this function is used to project the image to a rear projection screen.
power managementthis function turns projection lamp off when this projector detects signal interruption and is not used for a certain period in order to reduce power consumption and maintain the lamp-life. (this projector is shipped with this function on.)
power management function operates to turn projection lamp off when the input signal is interrupted and any button is not pressed over 5 minutes. this function operates as follows;
1. when any input signal is interrupted, "no signal" and the counting down display appears (for 5 minutes).
2. when projection lamp turned off, ready indicator turns off. cooling fans operate and projection lamp is turned off for 90 seconds. (during this "cooling down" period, projector cannot be turned on.)
3. when projection lamp has cooled down, ready indicator flashes and projection lamp can be turned on again (power management mode).
in this power management mode, projection lamp is automatically turned on when the input signal connected or projector is operated with any button on top control or on remote control unit again.
on startwhen this function is "on," projector is automatically turned on just by connecting ac power cord to a wall outlet.
be sure to turn projector off properly (refer to the section "turning off the projector" on p19). if projector is turned off in the wrong steps, on start function does not operate properly.
remote controlthis projector has two different remote control codes; the factory-set normal code (code 1) and the secondary code (code 2). this switching function prevents remote control operation mixture (jam) when operating several projectors or video equipment together. when operating projector in "code 2," both projector and remote control unit must be switched to "code 2."
to change the code of projector;
set remote control in the setting menu to "code 2."
to change the code of the remote control unit;
press both menu and image buttons on remote control unit together for over 10 seconds.
after changing the code, make sure remote control operates properly.
to return to the normal code (code 1), operate both projector and remote control in the ways above again.
when batteries of remote control unit are replaced or alloff switch is turned to "all-off," the remote transmit code automatically returns to the normal code (code 1).
lamp counter resetthis function is used to reset lamp replace counter. when replacing projection lamp, reset lamp replace counter by using this function. refer to page 39 for operation.
