when the life of projection lamp of this projector draws to an end, lamp replacement indicator lights yellow. when a projected image becomes dark or the color of an image becomes unnatural, replacement of projection lamp is required.

    1、for continued safety, replace with a lamp assembly of the same type.

    2、allow a projector to cool for at least 45 minutes before you open lamp cover. the inside of a projector can become very hot.

    do not drop a lamp assembly or touch a glass bulb! the glass can shatter and may cause injury.

    follow these steps to replace the lamp assembly.

    1 turn off the projector and disconnect ac plug. allow the projector to cool for at least 45 minutes.

    2 remove a screw with a screwdriver to remove lamp cover.

    3 remove 3 screws with a screwdriver and pull out lamp assembly by grasping handle.

    4 replace lamp assembly with a new one and tighten 3 screws back. make sure that lamp assembly is set properly. replace lamp cover and tighten a screw.

    5 connect ac power cord to the projector and turn it on.

    6 reset lamp replace counter (refer to the section "lamp replace counter" below).

    do not reset lamp replace counter when projection lamp is not replaced.

    order replacement lamp

    replacement lamp can be ordered through your dealer. when ordering projection lamp, give the following information to the dealer.

    · model no. of your projector : lv-7340 / lv-7345

    · replacement lamp type no. : lv-lp11

    (610 293 2751)