you are now ready to check if the scanner is operating properly and if the devices are correctly connected to your macintosh.

    check if the scanner is properly unlocked.

    1 connect the power cord to the scanner.

    make sure that you are using the correct power cord for the voltage in your area. double-check whether the voltage indicated on the back panel of the scanner corresponds with the voltage in your area. if not, contact your dealer or agfa service representative.

    2 check if the scsi cable is properly connected.

    3 switch on the scanner.

    while starting up the scanner, the power indicator (green) switches on after which the progress indicator switches on. the scanner performs a self-test for about 25 seconds. at the end of the self-test, the progress indicator will automatically go out if there are no problems. if a malfunction is detected during the self-test, that is, if the progress indicator remains blinking, consult appendix a: troubleshooting.

    4 switch on any other scsi device you may have attached, and wait for it to start up.

    5 switch on your macintosh.

    as it starts up, your macintosh performs a series of tests to verify the correct system configuration.

    6 open the scsi id checker.

    7 verify whether the macintosh sees the scanner at its proper scsi address.

    in case of problems, consult appendix a: troubleshooting.

    8 close the scsi id checker.