make sure the power switch is on．

    1 press"push open"and open the door．(fig．1)

   

    2 (1)load the copy paper roll．(fig．2)

   

   

    (2)pass the paper over the feed roller and under the paper guide，then through the printer solt about 4cm(11/2inches)，(fig．3)

   

    t to load 100m roll[diameter：about 94mm(311/16 inches)

    (1)open until position b and load it．then back it to position a to prevent paper roll，drop．(fig.4)

   

    (2)set the paper according to ltem 2-2．

    3 close the printer door securely．using two hands．

    oncd the door is closed,paper will feed and automatically cut．remove and discard the small piece of paper．

    load a new roll when：

    1 red bands become visible at the edge of the copy paper．

    2 the error indicator"p"goes on and off even after the printer door is closed properly．