5 reflective sensor (when using a manual threshold value)

    feeding takes place according to the parameters designated by the label size set command. however, the black mark provided on the back of the tag paper is automatically sensed by the reflective sensor and the paper position is finely adjusted every piece, according to the set threshold setting value (set using keys).

    (2) cut/non-cut

    this option is valid in batch feed mode only. (non-cut is selected in strip mode.) if no subsequent command is received from the pc for 3 seconds after cutfeeding when dip sw1-5 is set to on (with the automatic forward feed standby) in cut mode, the printer automatically performs a 10-mm forward feed.

    when the feed command is received in the forward feed standby state, the printer performs a reverse feed to the original position.

    * for notes, refer to the section regarding the issue command.

    for cutting the label having label pitch of 38 mm or less, refer to the section regarding the position fine adjustment command.

    (3) feed mode

    [batch (non-cut)]

   

    [batch (cut)]

   

    [strip (feed mode: d)]

   

    [strip (feed mode: e)]

    expansion i/o is installed:

    the strip sensor is ignored. a feed is performed by checking a pause signal generated from the expansion i/o.

   

    expansion i/o is not installed:

    the strip sensor is ignored. a feed is performed.

   

    *1 feed mode e is different from feed mode d. in feed mode e, a label is fed, regardless of the strip sensor, and whether or not a label to be stripped, is placed.

    *2: the peripheral device such as an applicator, must control the pause signal generated from the expansion i/o.

    (4) feed speed

    · feed the paper at the designated speed. ribbon saving and back feed also take place at the same designated speed. however, the back feed speed in cut mode or strip mode is 3”/sec.

   

    (5) with/without ribbon

    without ribbon: the ribbon motor is not operated at feed.

    with ribbon: the ribbon motor is operated at feed.

    with ribbon saving: when the dip switch is set to auto ribbon saving, ribbon

    saving will be performed automatically.

    when the option for no ribbon saving has been selected or

    the dip switch is set to no auto ribbon saving, no ribbon

    saving will take place.

    (1) if a change of label size or type of sensor, feed fine adjustment, cut position fine adjustment (or strip position fine adjustment) or back feed fine adjustment is made, one label must be fed to adjust the first printing position prior to printing.

    (2) the parameter of the feed command is protected in memory (protected even if the power is turned off).

    (3) when “status response” is selected in the issue command parameter setting, a status response is made after the end of feed or when an error occurs.

    (4) for explanation about the processing to stop the label at the home position, refer to the section regarding the issue command.

    examples

   

    10 print #1, esc$; ”d0762, 0820, 0732”; lf$; nul$;

    20 print #1, esc$; ”ax; +010, +000, +10”; lf$; nul$;

    30 print #1, esc$; ”t11c62”; lf$; nul$;

    40 print #1, esc$; ”c”; lf$; nul$;

    50 print #1, esc$; ”pc001; 0150, 0410, 1, 1, a, 00, b”; lf$; nul$;

    60 print #1, esc$; ”rc001; sample”; lf$; nul$;

    70 print #1, esc$; ”xs; i, 0004, 0011c6201”; lf$; nul$;