1. remove access door. first remove the 2 screws from the ends (fig.1). be sure to support the door during this step

    to avoid injury. lift the door slightly and pull away from the edge of the case.

    2. carefully unpack screen and roller assembly. leave packing paper on roller.

    3. the roller mounting brackets are adjustable to allow for centering or offsetting the screen within the case. loosen

    the 4 setscrews on each bracket and slide the brackets towards the ends of the case.

    4. insert one end of the roller into the mounting bracket. the mounting brackets have a foam pad that the slat bar will

    rest against. be sure to install the roller assembly so the slat bar is positioned below these pads (fig. 2).

    5. slide the other mounting bracket onto the roller pin. at this time you may need to center the roller assembly within

    the case. you may need two people to slide the mounting brackets while holding the roller assembly. tighten all 8

    setscrews securely.

    6. re-install the access door. procedure is reverse of removal.