2. disengage the printer carriage by pulling the printer carriage release lever on the left side of the platen.
3. slide the label supply roll spindle through the core of a label roll and attach the fixing tabs onto the spindle.
4. place the label roll into the label roll mount. feed the label under the carriage and over the platen.
5. adjust the label guide to fit the width of the media.
6. engage the printer carriage.
7. wind the label roll until it becomes adequately taut.
8. close the printer cover and press the feed button three or four times until the green on-line indicator illuminates.
9. when the printer is out of ribbon or media, the on-line led will not illuminate and the err. led will flash. reload the ribbon or media without turning off the printer power. press the feed button three or four times until the on-line led illuminates. the printing job will be resumed without data loss.
figure 5. inserting label supply roll into label roll mount
1. label supply roll spindle
2. label roll mount
3. label roll
4. fixing tabs
figure 6. feed labels through adjustable label guide
1. printer carriage release lever
2. platen
3. label media
4. adjustable label guide