1. remove the front panel.
2. tear off the foremost one or two labels of the label stock, as befits the case.
feed the backing paper between the platen and the white "self-peeling" roller, as shown in figure 7.
3. feed the backing paper through the backing paper opening in the front panel, as shown in figure 8.
4 put back the front panel.
figure 7. setting up printer for self-peeling function
1. printer carriage release lever
2. platen
3. self-peeling roller
4. backing paper
it is recommended that the print speed be set at 2 inches (1.5 inches for ttp/tdp 342) per second when using the self peeling function of the printer.
figure 8. printer ready for self-peeling function
1. printer carriage release lever
2. printer front panel
3. backing paper opening
4. backing paper
5. label
the e series printers are not equipped with the self-peeling device.