the following configuration programs are available to configure your computer:

    1 configuration/setup utility program

    the configuration/setup utility program is part of the basic input/output system (bios) code that comes with your computer. you can use this program to configure serial port assignments, change interrupt request (irq) settings, change the device startup sequence, set the date and time, set passwords, and set the chassis-intrusion alert. see “using the configuration/setup utility program”.

    2 lsi logic configuration

    utility with the built-in lsi logic configuration utility program, you can configure the integrated scsi controller with raid capabilities and the devices that are attached to it. see “using the lsi logic configuration utility program” on page 24.

    3 serveraid manager

    the serveraid programs come with your computer. if your computer has a serveraid controller installed, or if you are using the integrated scsi controller with raid capabilities as a raid controller, you must use the serveraid manager program to define and configure your disk-array subsystem before you install your operating system. see “using serveraid manager” on page 25 for more information.

    4 ethernet controller configuration process

    to configure the integrated ethernet controller, see “configuring the gigabit ethernet controller” on page 26.