you can apply filters to incoming or outgoing data in a remote node connection and also use filters to cause or prevent the placement of outgoing calls to the remote node. to use filters, start by defining the filters using menu 21 - filter set configuration as shown in figure 8-4.

   

    after defining filters in menu 21, apply the filters to the remote node by entering the filter number in menu 11.5 - remote node filters. you can cascade up to four filter sets by entering the numbers of the desired filter sets, separated by commas and with no spaces between them.

    menu 11.5 - remote node filters is shown in figure 8-5.

   

    table 8-3 describes the fields of the remote node filters display.

    table 8-3. remote node filters fields

   

    for more information on using filters, refer to chapter 10, “configuring filters.”