2. connect the male 10-pin rj45 end of the powerlink cable to the jack on the ms7120.
3. connect the l-shaped plug of the power supply into the power jack on the powerlink cable.
4. make sure the ac input requirements of the power supply matches the ac outlet. plug the power supply into the ac outlet. the outlet should be near the equipment and easily accessible.
5. disconnect the keyboard from the pc. note the type of connector on the keyboard and keyboard port on the pc.
6. the "y" end of the powerlink cable terminates to female 5-pin din and a male 6-pin mini din connector. if necessary attach the supplied adapter cable to the appropriate end of the "y" cable.
7. connect one end of the "y" cable to the keyboard and other end of the "y" to the keyboard port on the pc.
8. power up the pc.
manufacturer's recommendation:
powering orbit directly from the computer can sometimes cause interference with the operation of the scanner or the computer. not all computers supply the same current through the keyboard port, explaining why a scanner will work on one computer and not another. metrologic recommends using an external power supply. for additional information contact a metrologic customer service representative.
1、to maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements for selv (safety extra low voltage) according to en 60950.
2、to maintain compliance with standard csa c22.2 no. 950/ul 1950 and norm en 60950, the power source should meet applicable performance requirements for a limited power source.