one beep
when the scanner first receives power, the green led will turn on, then the red led will flash and the scanner will beep once. (the red led will remain on for the duration of the beep.) the scanner is now ready to scan.
when the scanner successfully reads a bar code, the red led will flash and the scanner beeps once (if programmed to do so). if the scanner does not beep once and the red light does not flash, then the bar code has not been successfully read.
razzberry tone
this is a failure indicator. refer to failure modes page 11.
three beeps - during operation
during operation of the scanner, the red led will flash while the scanner simultaneously beeps three times (while going into programming mode).
the red led will continue to flash until the unit exits program mode. upon exiting program mode, the scanner will beep three times and the red led will stop flashing. when configured, 3 beeps can also indicate a communications timeout during normal scanning mode. when using onecode programming, the scanner will beep three times (the current selected tone), followed by a short pause then by a high tone and a low tone. this tells the user that the single configuration bar code has successfully configured the scanner.
three beeps - on power up
this is a failure indicator. refer to failure modes page 11.