a. locking plate
[mlpn 50-50302] qty. 1
b. base cover
[mlpn 50-50301] qty. 1
c. wood screw, #7 x 1.00"
[mlpn 18-18013] qty. 3
d. flathead screw, m3 x 8 mm
[mlpn 18-18004] qty. 4
1. drill mounting holes
note the position orbit will rest (fig. 2). use the dimensions provided in figure 2 or the locking plate [mlpn 50 50302] as a template to drill three #39 pilot holes.
2. mount locking plate to wall/counter
secure the locking plate [mlpn 50-50303] to the counter or wall with the three #7 x 1.00" wood screws [mlpn 18-18013] provided.
3. attach the base plate to orbit
secure the base cover [mlpn 50-50301] to the bottom of orbit (fig. 4) using the four m3 x 8 mm screws [mlpn 18-18004] provided.
4. mount orbit to locking plate
hold orbit 90° clockwise from the desired position then lower it over the locking plate until it sits flush to the countertop. twist orbit counter clockwise 90°, as shown in figure 5, to lock unit in place.
