2. determine if your application requires usb keyboard communication protocols or usb point of sale communication protocols.
3. if you require usb keyboard communication protocols, skip to step 4.
if you require usb point of sale communication protocols:
· remove the ms7600 top cover.
· insert the pos plug (mlpn 46-46640) into the slot indicated in figure 16.
· replace the top cover.
4. connect the powerlink usb cable to the 2↑nd jack down from the top of the ms7600.
5. connect the other end of the usb cable to the host.
before continuing verify that the usb powerlink cable is connected to the appropriate interface jack on the scanner. an incorrect cable connection can cause communication problems or potential damage to the scanner.
continued on next page.
1.to maintain compliance with applicable standards, all circuits connected to the scanner must meet the requirements for selv (safety extra low voltage) according to en 60950.
2.to maintain compliance with standard csa c22.2 no. 60950-00/ul 60950 and norm en 60950, the power source should meet applicable performance requirements for a limited power source.
manufacturers note:
plugging the scanner into the usb port of the pc does not guarantee that scanned information will appear at the pc. a software driver and correct configuration setting are also required for proper communication to occur.
6. scan the enable usb defaults bar code to configure the ms7600 for usb communication.
7. turn on the host system.