when the "mx" receiver first receives power, the unit will beep once.
if the scanner successfully reads a bar code, the green light will flash. if the "mx" receiver successfully receives the data from the ms6130, the "mx" will beep once.
if, upon power up, the scanner emits a razzberry tone, then the scanner has failed diagnostics.
the "mx" receiver will emit a razzberry tone if an invalid bar code is scanned while the receiver is in program mode.
the "mx" receiver can be programmed to emit a razzberry tone when the timeout occurs during communication between the host and receiver.
refer to the ms4120 programming guide section, audible indicators for communication timeouts to program this feature.
the ms6130 scanner will quietly beep twice when scanning a bar code if the batteries become low.
when scanning the ms6130 enter/exit program mode bar code in the ms4120 programming guide, the green led will flash three times while the scanner simultaneously beeps three times. when exiting the program mode, the same visual and audible indications will occur. after this sequence is completed, the red led will turn off. when scanning the enter/exit program mode for the receiver bar code, the "mx" receiver will beep three times to indicate it is in or exiting out of the program mode.
(continued next page)
the "mx" receiver can be programmed to emit three beeps when the timeout occurs during communication between the host and receiver. refer to the ms4120 programming guide section, audible indicators for communication timeouts to program this feature.
there are four settings available for the tone of the beep for the receiver. refer to the ms4120 programming guide section, beeper tones to program the feature to change the tone or turn the beeper off.