frequencies: one of the following depending on the
country of operation:
418 mhz
434 mhz
912 mhz
bandwidth: 220 khz
modulation: fm
certification: no fcc licensing required
rf protocol: one way data transmission
transmission time at a maximum of 100 ms
50k baud data rate
dedicated transmitter(s) to receiver link
operating range: up to 30 feet (conditions permitting)
specifications subject to change without notice
ms6130 bar code scanner specifications
ul listed: us and canada
fcc id: lw5613 (912 mhz only)
rf output power: 20 uw max. (912 mhz only)
current: supplied by rechargeable/replaceable
batteries
antenna: integral
dimensions:
length 216 mm [8.5"]
width 63 mm [2.5"] head and 48 mm [1.9"] handle
height 28 mm [1.1"]
weight: 289 g [10.5 oz]
maximum radiant power: 0.9 mw peak
vld wavelength: 630 nm to 680 nm
mx003 series scanner interface specifications
fcc id: lw5003
operating voltage: 5vdc
antenna: integral
dimensions: 90 mm [3.54"] x 50 mm [1.97"] x 24 mm [0.94"]
weight: 80.3 g [2.8 oz]
ul listed: us and canada
model designation may include the suffix "j" used to indicate the addition of an audio signal output jack.
specifications of battery pack
battery type: "aa" nicd rechargeable
configuration: 3 batteries/pack
nominal voltage: 3.6 vdc
maximum voltage: 4.8 vdc
capacity: 600 ma
charge cycles: over 500 full charge/discharge
charge time: 4 hours
short circuit protection: auto/reset fuse 1.7a hold current
temperature characteristics (degrees celsius) of each cell:
charge: 0 to +45
discharge: -20 to +60
storage (long): -30 to +35
uk compliance
to charge the batteries in the ms6130 - 418mhz, remove the esd cover from the bottom of the unit. refer to the battery charge rate for additional information. after a full charge, replace the cover over the battery contacts. the cover should remain in place during operation