power on the system only after all of the following steps are completed:

    1 connect all i/o drawer cables

    2 connect the base system cables

    3 connect all pci cables to supported subsystems

    4 connect the hardware management console (hmc) (if required)

    5 connect power the system

    after the required cables are installed and the power cables are connected, the hmc user interface provides a power-on function to turn on the power to the system. if a system operator panel is available, the power button on the operator panel can be pushed to initialize the system, but the preferred method is to use the hmc if booting logical partitions. progress indicators, also referred to as checkpoints, are visible on the operator panel display (if available) as the system power is turned on. the power led on the base system stops blinking and stays on, indicating the system power is on.

    the base system and i/o subsystems are powered on through the system power control network (spcn).

    when power is applied, the power leds on the base system go from blinking to continuous, and the power leds on the i/o subsystem(s) come on and stay on. this indicates that power levels are satisfactory in the subsystems.

    after the system is powered on, all logical partitions will be in a standby or powered on state. each logical partition must then be booted via the hmc. all logical partitions that have been booted will be in the running state.