dos lan services

    due to a problem with the dls installation utility, you need to complete the following steps before executing the installation of dls:

    1 on dls diskette 1, make a directory off the root called ndis.

    2 copy the file e100b.dos (10/100 mbit) or e1000.dos (for gigabit) from the \dos directory of the configuration and drivers disk into this new directory \dos on dls disk 1.

    3 run the dos lan services installation program at the dos workstation. follow the prompts.

    4 when presented with an adapter list, select network card not shown in list below.

    5 when prompted for the location of the oemsetup.inf file, insert the configuration and drivers disk in your drive and enter [drive]:\dos as the path.

    6 select the intel adapter from the list. follow the prompts.

    7 enter your machine name, user name and domain name.

    8 set the options as you need; then highlight "the listed options are correct" and press [enter].

    9 accept the defaults on the next screen, highlight "the listed options are correct" and press [enter].

    10 set the speed, duplex mode, or slot device if needed. we recommend accepting the defaults. then, highlight "the listed options are correct" and press enter.

    11 you may be asked to insert dls disks. follow the prompts to complete the installation and restart your computer for changes to take effect.

    general installation under dos - lan support program (lsp)

    1 run dxmaid from the lan support program disk.

    2 follow the prompts and instructions.

    3 when prompted, insert the configuration and drivers disk and enter the pathname [drive]:\dos.

    4 the default configuration is suitable for most environments. we recommend accepting the defaults.

    5 after the installation is complete, restart your computer for the changes to take effect.

    general installation under dos - dos lan requester

    1 run the dos lan requester installation program at the dos workstation. follow the prompts to configure your dos lan requester as required.

    2 after the installation is complete, restart your computer for the changes to take effect.