1 ensure that the printer is placed in the depression on the top of the stand (option). if the printer is used without a stand, align the printer with the front against the resistance and remove by pulling forward. edge of the table. the cables at the back of the printer should be tucked into the cable clips in order not to block the paper path.

    2 hold the front of the manual insertion guide (4) on both sides, pull upwards

   

    3 pull the green tractor lock levers (12) toward you to release the tractors.

    4 lock both green tractor levels

    5 roughly adjust the tractors (13) to the paper width, and space out the paper supports (14) evenly.

   

    6 open the tractor covers (16) and insert the paper.

    7 close the tractor covers.

    8 tighten the upper edge of the fanfold paper by slightly pushing the right tractor to the right. make sure not to stress the paper too much.

    9 lock the tractors by pushing back the green lock lever again.

   

    10 reapply the manual front insertion guide

    if you do not refit the manual front insertion guide, there is no guarantee for a proper paper transport and accurate printing.

    11 select the paper source tractor using either the menu selection of the printer or your software (chapter 1.9).

    12 initiate a printout (chapter 1.10), to check the margins. readjust the tractors until the printout appears within the desired margins.