after you turn on power to the firewall, the following sequence of events should occur:

    1.when power is first applied, verify that the power led is on.

    2.verify that the test led lights within a few seconds, indicating that the self-test procedure is running.

    3.after approximately 10 seconds, verify that:

    a.the test led is not lit.

    b.the local port link leds are lit for any local ports that are connected.

    c.the internet link port led is lit.

    if a port’s link led is lit, a link has been established to the connected device. if a port is connected to a 100 mbps device, verify that the port’s 100 led is lit.

    if any of these conditions does not occur, refer to the appropriate following section.