when the firewall is turned on, the test led turns on for about 10 seconds and then turns off. if the test led does not turn on, or if it stays on, there is a fault within the firewall.

    if you experience problems with the test led:

    cycle the power to see if the firewall recovers and the led blinks for the correct amount of time.

    if all leds including the test led are still on one minute after power up:

    1 cycle the power to see if the firewall recovers.

    2 clear the firewall’s configuration to factory defaults. this will set the firewall’s ip address to 192.168.0.1. this procedure is explained in “using the default reset button” on page 8-8.

    if the error persists, you might have a hardware problem and should contact technical support.