2. remove the battery cover by sliding the battery cover release button up 1 and pulling the battery cover away from the unit 2.
3. slide in the battery (with the label side up) so that the connectors on the right side are fully seated on the pins 1. then push the left side of the battery in place 2.
4. re-install the battery cover by matching the tabs on the battery cover to the latches on the ipaq pocket pc, then snap into place.
ATTENTION： the ipaq pocket pc will not operate if the battery cover is not installed.
ATTENTION： you will need to fully charge your ipaq pocket pc within the next 12 hours. the amber charge light is flashing (blinking) when your ipaq pocket pc is recharging the battery. the charge light turns solid amber when the battery is fully charged.