a battery is installed in the remote control at the time of purchase.
1 pull out the battery insulation sheet.
once the battery insulation sheet is removed, the remote control is ready for use.
2 perform the remote control setting at the digital disk camera (see page 124).
the remote control setting must be set properly in order to use the remote control to operate the digital disk camera.
at the time of purchase, the digital disk camera is already set so that the remote control can be used.
using the remote control
the remote control must be used within a seven-meter distance from the remote control sensor, between 15 degrees to the left and right on the horizontal. if there is an obstruction between the remote control and its remote control sensor, it may block the signal and prevent operation of the digital disk camera by the remote control. if this is the case, remove the obstruction.
each button on the remote control performs the same operation as the button of the same name on the digital disk camera (see page 22).
when an operation is performed with the remote control, the self-timer lamp lights for one second to signal that the signal has been received.
if the remote control is located to the front and right of the digital disk camera, the digital disk camera lens may block its signal. if this is the case, change your position.
the signal range of the remote control may be decreased if used under bright sunlight or inverted lighting. this is a characteristic of infrared remote controls and not a malfunction. to reduce problems during use, do not allow such light to enter the remote control sensor.
replacing the remote control battery
the life of the lithium battery will depend on your use of the remote control, but as a general guideline, it will require replacement approximately once a year. at that time replace it only with the commercially available cr2025 lithium battery.
1 pull out the battery holder.
push in the tab to release the battery holder and then pull it out.
2 remove the battery.
3 insert the new battery (cr2025).
?wipe the new battery with a soft, dry cloth and then insert it with the (+) mark facing upward.
4 push in the battery holder.
changing the remote control code
this remote control will also work with other sanyo cameras that can be operated by infrared remote control. therefore, when more than one camera is present, it is recommended to change the remote control code to ensure that only the intended camera operates when the remote control is used. the remote control code is set to “1” at the time of purchase.
changing the remote control code from “ 1” to “ 2”
1 aim the infrared emitter at the remote control sensor on the digital disk camera.
2 hold down the ch button and press the w button for more than three seconds.
the self-timer lamp lights for one second when the remote control code changes to “2.” release the buttons on the remote control.
3 press a button on the remote control and check that the operation was carried out correctly.
?the remote control code is not lost even if you replace the battery in the remote control.
?if the remote control codes for the remote control and digital disk camera do not match, operations will not be carried out.
returning the remote control code to “ 1”
1 aim the infrared emitter at the remote control sensor on the digital disk camera.
2 hold down the ch button and press the t button for more than three seconds.
the self-timer lamp lights for one second when the remote control code returns to “1.”
release the buttons on the remote control.