creating a playback program
follow the procedure below to set the order of the slide show. to do this you will create a program that specifies the files to play back. the program will then be saved onto the disk.
preparation
1 move the write-protect tab on the disk to the write-enabled position (see page 155).
·the program playback selection screen appears.
to return to the option screen: select "exit"
to create a playback program: select "viewer"
?1 the program playback setting screen appears.
?2 “rogram” is selected initially.
3 press the set button.
?the compile program screen appears.
folder: for selecting the folder where the files you want to play back are located
image sel: for selecting still images to play back
movie sel: for selecting video clips to play back
save: for saving the program
6 press the set button.
1 the 9-image playback screen appears.
?2 if “no image” appears, then there are no files of the type selected.
7 select the files in the order you want them to be played back.
1 a check mark is placed on the selected file.
?2 to erase the check mark, press the set button again.
?3 to change folders or type of file, press the mode button to display the compile program screen and repeat steps 4 to 6.
8 press the mode button.
?1 you return to the compile program screen.
?2 proceed to steps 9 and 10. at this point, the program has not yet been saved.
?1 it will take a few moments for the program to be saved to the disk.?
2 once saved, the save program screen appears with the program number.
?3 in the example given on the right, the program was assigned the program number “0001”.
10 press the set button.
?1 the compile program screen appears. the program has been compiled and saved.
?2 to return to the program playback setting screen, press the mode button. to then return to the program playback selection screen, press the mode button again, or select “exit”?and press the set button. to then return further back to the playback setting screen, press the mode button, or select “exit”?and press the set button.
selecting a playback program and starting playback
follow the procedure below to select a playback program and start the playback.
1 the playback program is selected and playback begins.
?2 to stop the playback, press the mode button.
?3 when playback is completed, you return to the program playback selection screen.
erasing a playback program
follow the procedure below to erase a playback program that is no longer needed.
1 display the program playback setting screen.
?perform steps 1 and 2 on page 144.
?1 the program deletion screen appears.
?2 if “no program” appears, there are no programs stored.
?1 the selected program is erased.
?2 if all programs are erased, you return to the program playback setting screen.