a calibration must be performed when media and ribbon (if used) are first installed in the printer, or when a different type of media or ribbon is being used.

    fanfold media feeds through either the bottom or rear access slot from outside the printer.

    refer to figure 21 and figure 22.

    1. open the printhead.

    2. slide the media guide as far from the printer frame as possible.

    3. load media as shown. if the printer is in cutter mode, route the media through the cutter.

    4. slide in the media guide so it just touches, but doesn’t restrict, the edge of the roll.

    5. close the printhead.