you can leave the program mode at any time by pressing the setup/exit key. the “save changes”display appears. there are five choices, as described below. pressing the left or right black oval key displays other choices and pressing the next/save key selects the displayed choice.?permanent ?permanently saves the changes. values are stored in

    1 permanent ?permanently saves the changes. values are stored in the printer even when power is turned off.

    2 temporary ?saves the changes until you change them again or until power is turned off.

    3 cancel ?cancels all changes from the time you pressed the setup/exit key except the darkness and tear-off settings (if they were changed).

    4 load defaults ?loads factory defaults. the factory defaults are shown on the following pages.

    loading factory defaults requires printer calibration.

    5 load last save ?loads values from the last permanent save.