the reflective sensor detects the tart-of-label indicator?(the notch, hole, black mark, or gap between die-cut labels).

    the reflective sensor must be positioned:

    1 directly under the notch, hole, or black mark, or

    2 anywhere along the width of the media if there is a gap between labels

    the glow of the red light through the media helps you to accurately position the reflective sensor.

    if you are using continuous media, position the reflective sensor anywhere under the media so that the printer can detect an out-of-paper condition.

    the reflective sensor is compatible with most types of media.however, if you encounter difficulties with calibration, use the transmissive sensor. for details, see “transmissive sensor” on page 10.