this option is available on the z4m printer only.
refer to figure 17.
1. press the printhead open lever. the printhead assembly springs up.
2. flip down the media supply guide.
3. slide out the media guide as far from the printer frame as possible.
4. place the roll of media on the media supply hanger and orient the media properly.
5. flip up the media supply guide.
6. slide in the media supply guide so that it just touches, but does not restrict, the edge of the roll.
7. feed the media under the dancer, through the slot in the transmissive sensor, and under the ribbon sensor.
8. pull approximately 18" (500 mm) of media through the front of the printer.
9. remove the labels from the exposed media so that only the liner remains.
10.ensure that the media is against the back of the transmissive sensor. slide in the media guide so that it just touches, but does not restrict, the edge of the media.
11.pull down the value peel lever to open the value peel assembly.
12.feed the media over the tear-off/peel-off bar and behind the value peel assembly.
13.close the printhead assembly.
14.close the value peel assembly using the value peel lever.
15.slide the liner into the slot (see inset) in the spindle of the liner take-up (as shown in figure 17). make sure the liner is resting against the back plate of the spindle assembly.
16.turn the spindle assembly counterclockwise a few times so that the liner is snug.
17.if the printer is paused (the pause light is on), press the pause key to enable printing.
peeling starts automatically. press the feed key to test.
1. pull the liner slide toward you (see inset) until it stops (about a third of the way down the liner take-up spindle).
2. slide the liner from the take-up spindle.
the liner slide moves smoothly back into place on the liner take-up spindle once the liner has been removed.