you can leave the program mode at any time by pressing the setup/exit key. the “save changes?display appears. there are five choices, which are described below. pressing the increment (+) or decrement (? key displays other choices and pressing the select key selects the displayed choice.

    1 permanent—permanently saves the changes. values are stored in the printer even when power is turned off.

    2 temporary—saves the changes until you change them again or until power is turned off.

    3 cancel—cancels all changes from the time you pressed the setup/exit key except for darkness and tear-off settings (if they were changed).

    4 load defaults—loads factory defaults.

    5 load last save—loads values from the last permanent save.