for personnel safety,always turn off and unplug the printer before performing this procedure.
refer to figure 27.
to clean adhesive off of the upper and lower cutter blades:
1. remove the cutter shield by removing the thumbscrew and lock washer.
2. use a swab moistened with solvent to wipe along the upper cutter blade.
3. to expose the lower cutter blade, turn the cutter motor thumbnut counterclockwise until you see the “v”-shaped lower cutter blade.
4. clean the lower blade, following the instructions in step 2.
5. replace the cutter shield.
6. when you have finished cleaning the cutter module, plug in and turn on the printer. the lower cutter blade returns to its correct operating position. if the cutter continues to perform unsatisfactorily, contact an authorized service technician.
