the width of the laser beam emitted from the data collector can be adjusted to match the width of the bar code that is being read.

    when you switch the laser beam width, you must set the beam’s reference point beforehand.

   

   

    3 press the trigger key to emit the laser beam, and align the laser beam with the beam width adjustment bar code.

    * align the laser beam with the fine bars on both sides of the adjustment bar code.

   

    (example)

   

    after first making sure that the laser beam is emitted at the correct position, hold down the trigger key for at least one second.

    laser beam adjustment is completed when you release the trigger key.

   

    beam width adjustment bar code

    for down-facing reader port model

   

    for forward-facing reader port model

   

    [handling precautions]

    1 the data collector is shipped with the laser beam width already adjusted. so, the laser beam width need not be adjusted. adjustment is necessary only when the laser beam does not switch to the correct position when the beam width is switched.

    1 adjustment results are stored in memory.

    2 factory settings are returned to if the data collector is reset or all built-in batteries are removed, preventing memory backup.

    2 if adjustment is not successful, an error message is displayed. if this happens, retry adjustment.