when you are using the down-facing reader port model, remove the nose guide attached to the data collector, and attach the wall unit screw to a using the screws (supplied). when you are using the forward-facing reader port model, attach the wall unit screw to b using the screws (supplied) with the nose guide still attached.
2 remove the installation covers (l, r).
3 attach the wall units. insert the wall units into the holes, and then fix them in place by sliding them downwards.
4 remove the two screws (one each at the top and bottom) that secure the base to the satellite cradle.
5 pressing down on the four corners of the satellite cradle base, unhook the tabs, and remove the base from the unit.
6 position the base on the wall where you want to hang the satellite cradle, and use an awl or some other sharp object to mark the positions of the two wood screws.
7 slip a spacer over each of the wood screws and then drive the screws into the wall at the positions you marked in the previous step. make sure that the spacers are oriented correctly. you will not be able to hook the satellite cradle onto the screws if the spacers are backwards.
8 re-attach the base to the satellite cradle, orienting it upside-down from its original mounting position when you removed it, and secure it in place with the two screws.
9 hook the satellite cradle onto the wall unit screws in the wall, and slide it down to lock in place.
·be sure to check the wood screws periodically for looseness and tighten if necessary after hanging the satellite cradle on a wall.